Glossary: basic and reference dimensions
Terms
- Glossary: basic and reference dimensions: Short, exact definitions of terms an inspector meets on a drawing, starting with basic dimension and reference dimension, each with how to record it in a report.
- Basic dimension: definition, the box, and how to report it: A basic dimension is a theoretically exact value shown in a box on a drawing, used with a feature control frame to locate or orient a feature. How to read one, and how to record it on an inspection report.
- Reference dimension: definition, brackets and whether to inspect it: A reference dimension is given for information only, shown in brackets, and is not inspected. How it differs from basic and toleranced dimensions, and whether it goes in an inspection report.
Why these two first
Basic and reference dimensions look alike to a newcomer, and getting them wrong produces reports that are either wrong or padded. A basic dimension is exact and gets its tolerance from a feature control frame. A reference dimension is for information and is normally not inspected. A toleranced dimension is the ordinary case: it carries its own plus and minus. If you cannot tell which kind a number is, look for a box (basic), brackets or the letters REF (reference), or a tolerance beside it.
Reading order
Read the basic dimension entry first, then the reference dimension entry. Together they explain most of the confusion over which numbers on a drawing deserve a result in a report.
One line for each entry
- Basic dimension: a boxed, theoretically exact value whose tolerance comes from a feature control frame.
- Reference dimension: a value in brackets or marked REF, shown for information and normally not inspected.
How to tell them apart on a real drawing
| Look for | It is | Inspect it? |
|---|---|---|
| A rectangle around the number | Basic | Through its frame |
| Brackets or REF | Reference | No |
| A tolerance beside it | Toleranced | Yes |
| Nothing at all | Toleranced by the title block | Yes, with the general tolerance |
Datums are explained on the datums page, material condition on the MMC and LMC page and abbreviations on the abbreviations page.
Where the terms appear in the tool
When you balloon a boxed dimension, set its requirement from the governing frame and add it with the GD&T builder. A reference dimension normally gets no balloon. A dimension with no tolerance uses the general tolerance that you set once in Tolerances and parts.
Related reading
See the reference pages for symbols and abbreviations, and the GD&T chart for the geometric tolerance symbols.