Tools: true position calculator and other client-side calculators

Last reviewed 19 November 2026 · Written by Paul, who also builds and supports the tool

These calculators run entirely in your browser. Nothing you type is sent to a server, every step of the calculation is shown, and results are compared in exact decimal arithmetic so a value exactly on a limit is reported as in tolerance.
Detail A · Pages

What is here

How they are built

Each calculator uses the same exact-decimal code as the report table, and is covered by automated tests that check the worked examples on the page. We show the formula next to the result so that you can check it by hand, which matters when a number goes into a report that someone will review.

What each tool does

Tool What it answers Where the numbers go
True position calculator Is a measured axis inside its position zone, with or without MMC bonus? Nowhere: browser only
The ballooning tool What is the report for a drawing, and is each result in tolerance? Nowhere: browser only

The calculator is deliberately small. It does one calculation, shows every step, and gives the same answer as doing it by hand with exact decimals. The ballooning tool is the larger product: it takes a drawing PDF and builds the numbered print and the report table.

How to check a calculator yourself

Run the page's worked example first: the position example gives an error of 0.2828 against a tolerance of 0.30. Then try a value exactly on the limit. A good calculator passes it, because a result on the limit is in tolerance, and it does that without rounding either way.

Mistakes people make with calculators

  • Trusting a result without reading the inputs back. A transposed digit gives a plausible wrong answer.
  • Comparing a radial value with a diameter tolerance.
  • Using a calculator's rounded display as an input to the next step.

What they do not do

They do not read your drawing, and they do not replace the judgement of the person who owns the inspection. They assume the numbers you type are the true ones from the drawing and the readings from your instrument. A calculator is only a way of avoiding arithmetic slips.

Suggestions

If a calculation would save you time while ballooning, tell us from the feedback link in the tool. We will build what shops actually ask for.

Open a drawing — free

Related

Do not scale drawingThird-angle projectionSheet 1 of 1balloonmydrawing.com
Built and supported by Paul: [email protected]. AS9102 is a standard of SAE International; this site is not affiliated with or endorsed by SAE. Nothing here reproduces the standard. Explanations are our own and are not legal or compliance advice.Privacy · Terms · Refunds